GNSS Receiver Evaluation Board with IRNSS support
- 50 x 55 x 17.3 mm, Four Layer PCB, with proper RF layout design and ground plane, to validate SkyTraq’s GNSS receiver module and Parry Technology’s PTNAV IRNSS receiver module.
- Suitable on-board patch antenna supporting L1 and L5, External antenna provisioning through SMA Connector and u.FL connector
- Board-to-Board connector for DC supply, UART (3.3V TTL Level) for navigational data to external MCU/SoC
- Input Supply: 5V ±5% DC
GNSS Receiver Module with IRNSS (NavIC) support
- Single-chip stand alone NavIC / GPS / GAGAN receiver capable of receiving L1 / L5 signals from NavIC, GPS satellites and GAGAN SBAS.
- Based on Skytraq PX100 chipset, this RoHs compliant Tiny 12mm x 16mm module has Phoenix positioning engine inside, featuring high sensitivity, low power consumption, and fast TTFF
- Separate RF input with saw filters for L5 and L1, enabling high out‐band interference rejection
- Fully autonomous module, automatically searches, acquires & tracks satellite signals and on tracking sufficient number of satellites with valid measurements, outputs 3D PVT data
- Startup time: ~1 sec hot start / <30 sec cold start
- Accuracy: 2.5m CEP, 0.1m/sec velocity, 0.12ns timing
- UART Output